1. Move interrupt handling to a separate function to clean up main commit() function a bit. Also gate the function call off properly based on whether or not there are outstanding interrupts, and the system is not in PAL mode.
2. Better handling of updating instruction's status bits. Instructions are not marked "atCommit" until other stages view it (pushed off to IEW/IQ), and they have been properly handled (faults).
3. Don't consider the ROB "empty" for the purpose of other stages until the ROB is empty, all stores have written back, and there was no store commits this cycle. The last is necessary in case a store committed, in which case it would look like all stores have written back but in actuality have not.
src/cpu/o3/commit.hh:
Slightly modify how interrupts are handled. Also include some extra bools to keep track of state properly.
src/cpu/o3/commit_impl.hh:
Slightly modify how interrupts are handled. Also include some extra bools to keep track of state.
General correctness updates, most specifically for when commit broadcasts to other stages that the ROB is empty.
--HG--
extra : convert_revision : 682ec6ccf4ee6ed0c8a030ceaba1c90a3619d102
1. Update packet's flags properly when a snoop happens
2. Don't allow accesses to read a block's data if the block has outstanding MSHRs. This avoids a RAW hazard in MP systems that the memory system was not detecting properly earlier (a write required a block to upgrade, and while the upgrade was outstanding, a read came along and read old data).
3. Update MSHR's request upon a response being handled. If the MSHR has more targets than it can respond to in one cycle, then its request must be properly updated to the new head of the targets list.
src/mem/bus.cc:
Update packet's flags properly upon snoop.
src/mem/cache/cache_impl.hh:
Be sure to not allow accesses to a block with outstanding MSHRs.
src/mem/cache/miss/miss_queue.cc:
Update MSHR's request upon a response being handled.
--HG--
extra : convert_revision : 76a9abc610ca3f1904f075ad21637148a41982d6
src/cpu/o3/iew_impl.hh:
Allow for slightly more flexible handling of non-speculative instructions. They can be other classes now, such as loads or stores.
Also be sure to clear the state associated with squashes that are not used. i.e. if a squash due to a memory ordering violation happens on the same cycle as an older branch squashing, clear the state associated with the memory ordering violation.
Lastly don't consider uncached loads to officially be "at commit" until IEW receives the signal back from commit about the load.
src/cpu/o3/inst_queue_impl.hh:
Don't consider non-speculative instructions to be "at commit" until the IQ has received a signal from commit about the instruction. This prevents non-speculative instructions from being issued too early.
src/cpu/o3/mem_dep_unit_impl.hh:
Clear instruction's ability to issue if it's replayed.
--HG--
extra : convert_revision : d69dae878a30821222885485f4dee87170d56eb3
1. Requests are handled more properly now. They assume the memory system takes control of the request upon sending out an access.
2. load-load ordering is maintained.
src/cpu/base_dyn_inst.hh:
Update how requests are handled. The BaseDynInst should not be able to hold a pointer to the request because the request becomes owned by the memory system once it is sent out.
Also include some functions to allow certain status bits to be cleared.
src/cpu/base_dyn_inst_impl.hh:
Update how requests are handled. The BaseDynInst should not be able to hold a pointer to the request because the request becomes owned by the memory system once it is sent out.
src/cpu/o3/fetch_impl.hh:
General correctness fixes. retryPkt is not necessarily always set, so handle it properly. Also consider the cache unblocked only when recvRetry is called.
src/cpu/o3/lsq_unit.hh:
Handle requests a little more correctly. Now that the requests aren't pointed to by the DynInst, be sure to delete the request if it's not being used by the memory system.
Also be sure to not store-load forward from an uncacheable store.
src/cpu/o3/lsq_unit_impl.hh:
Check to make sure load-load ordering was maintained.
Also handle requests a little more correctly.
--HG--
extra : convert_revision : e86bead2886d02443cf77bf7a7a1492845e1690f
1. Set CPU ID in all modes for the O3 CPU.
2. Use nextCycle() function to prevent phase drift in O3 CPU.
3. Remove assertion in rename map that is no longer true.
src/cpu/o3/alpha/cpu_builder.cc:
Allow for CPU id in all modes, not just full system. Also include a parameter that was left out by accident.
src/cpu/o3/alpha/cpu_impl.hh:
Set the CPU ID properly.
src/cpu/o3/cpu.cc:
src/cpu/o3/cpu.hh:
Use nextCycle() function so that the CPU does not get out of phase when starting up from quiesces.
src/cpu/o3/rename_map.cc:
Remove assertion that is no longer true.
tests/configs/o3-timing.py:
Set CPU's id to 0.
--HG--
extra : convert_revision : 2b69c19adfce2adcc2d1939e89d702bd6674d5d5
fix unaligned accesses in mmaped disk device
src/arch/sparc/isa/decoder.isa:
get (ld|st)fsr ops working right. In reality the fp enable check needs to go higher up in the emitted code
src/arch/sparc/isa/formats/basic.isa:
move the cexec into the aexec field
src/cpu/exetrace.cc:
copy the exception state from legion when we get it wrong. We aren't going to get it right without an fp emulation layer
src/dev/sparc/mm_disk.cc:
src/dev/sparc/mm_disk.hh:
fix unaligned accesses in the memory mapped disk device
--HG--
extra : convert_revision : aaa33096b08cf0563fe291d984a87493a117e528
src/arch/sparc/floatregfile.cc:
fix fp read/writing to registers... looking for suggestions on cleaner ways if anyone has them
src/arch/sparc/isa/decoder.isa:
fix some fp implementations
src/arch/sparc/isa/formats/basic.isa:
add new fp op class that 0 cexec in fsr and sets rounding mode for the up comming op
src/arch/sparc/isa/includes.isa:
include the appropriate header files for the rounding code
src/arch/sparc/miscregfile.cc:
print fsr out when it's read/written and the Sparc traceflgas in on
src/cpu/exetrace.cc:
fix printing of float registers
--HG--
extra : convert_revision : 49faab27f2e786a8455f9ca0f3f0132380c9d992
src/arch/sparc/floatregfile.cc:
Fix serialization for fpreg
src/arch/sparc/intregfile.cc:
fix serialization for intreg
src/arch/sparc/miscregfile.cc:
fix serialization from miscreg
src/arch/sparc/pagetable.cc:
fix serialization for page table
src/arch/sparc/regfile.cc:
need to serialize nnpc
src/arch/sparc/tlb.cc:
write serialization code for tlb
src/cpu/base.cc:
provide a way to find the thread number a context is
serialize the instruction counter
src/cpu/base.hh:
provide a way to find the thread number a context is
and given a thread number find a context pointer
src/cpu/cpuevent.hh:
provide method to get thread context from a cpu event for serialization
src/dev/sparc/t1000.cc:
src/dev/sparc/t1000.hh:
nothing to serialize in t1000
src/sim/serialize.cc:
src/sim/serialize.hh:
Make findObj() work (it hasn't since we did the python conversion stuff)
--HG--
extra : convert_revision : a95bc4e3c3354304171efbe3797556fdb146bea2
src/arch/sparc/isa/base.isa:
Added passesFpCondition function to help with fbfcc and fbpfcc instructions.
src/arch/sparc/isa/decoder.isa:
Added fbfcc and fbpfcc instructions, and cleaned up branch code slightly.
src/arch/sparc/isa/formats/branch.isa:
Minor cleanup.
--HG--
extra : convert_revision : 6586b46418f1f70bace41407f267fee30c657714
make fp writes also chatty with the Sparc traceflag
src/arch/sparc/floatregfile.cc:
make fp writes also chatty with the Sparc traceflag
src/cpu/exetrace.cc:
fix comparing fp registers between legion and m5
--HG--
extra : convert_revision : f3703afae56249f137451262bc1b6919d465e714
SConstruct:
src/SConscript:
Add flags for Intel CC while i'm at it
src/base/compiler.hh:
the _Pragma stuff needst to be called this way unless someone happens to have a cleaner way
src/base/cprintf_formats.hh:
add std:: where appropriate
src/base/statistics.hh:
use this->map since icc was getting confused about std::map vs the locally defined map
src/cpu/static_inst.hh:
Add some more dummy returns where needed
src/mem/packet.hh:
add more dummy returns where needed
src/sim/host.hh:
use limits to come up with max tick
--HG--
extra : convert_revision : 08e9f7898b29fb9d063136529afb9b6abceab60c
into zower.eecs.umich.edu:/eecshome/m5/newmem
src/arch/sparc/isa/formats/mem/util.isa:
src/arch/sparc/isa_traits.hh:
src/arch/sparc/system.cc:
Hand Merge
--HG--
extra : convert_revision : d5e0c97caebb616493e2f642e915969d7028109c
