gem5/dev/ide_ctrl.hh

222 lines
7 KiB
C++
Raw Normal View History

/*
* Copyright (c) 2004 The Regents of The University of Michigan
* All rights reserved.
*
* Redistribution and use in source and binary forms, with or without
* modification, are permitted provided that the following conditions are
* met: redistributions of source code must retain the above copyright
* notice, this list of conditions and the following disclaimer;
* redistributions in binary form must reproduce the above copyright
* notice, this list of conditions and the following disclaimer in the
* documentation and/or other materials provided with the distribution;
* neither the name of the copyright holders nor the names of its
* contributors may be used to endorse or promote products derived from
* this software without specific prior written permission.
*
* THIS SOFTWARE IS PROVIDED BY THE COPYRIGHT HOLDERS AND CONTRIBUTORS
* "AS IS" AND ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT
* LIMITED TO, THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR
* A PARTICULAR PURPOSE ARE DISCLAIMED. IN NO EVENT SHALL THE COPYRIGHT
* OWNER OR CONTRIBUTORS BE LIABLE FOR ANY DIRECT, INDIRECT, INCIDENTAL,
* SPECIAL, EXEMPLARY, OR CONSEQUENTIAL DAMAGES (INCLUDING, BUT NOT
* LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS OR SERVICES; LOSS OF USE,
* DATA, OR PROFITS; OR BUSINESS INTERRUPTION) HOWEVER CAUSED AND ON ANY
* THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT LIABILITY, OR TORT
* (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY OUT OF THE USE
* OF THIS SOFTWARE, EVEN IF ADVISED OF THE POSSIBILITY OF SUCH DAMAGE.
*/
/** @file
* Simple PCI IDE controller with bus mastering capability and UDMA
* modeled after controller in the Intel PIIX4 chip
*/
#ifndef __IDE_CTRL_HH__
#define __IDE_CTRL_HH__
#include "dev/pcidev.hh"
#include "dev/pcireg.h"
#include "dev/io_device.hh"
#define BMIC0 0x0 // Bus master IDE command register
#define BMIS0 0x2 // Bus master IDE status register
#define BMIDTP0 0x4 // Bus master IDE descriptor table pointer register
#define BMIC1 0x8 // Bus master IDE command register
#define BMIS1 0xa // Bus master IDE status register
#define BMIDTP1 0xc // Bus master IDE descriptor table pointer register
// Bus master IDE command register bit fields
#define RWCON 0x08 // Bus master read/write control
#define SSBM 0x01 // Start/stop bus master
// Bus master IDE status register bit fields
#define DMA1CAP 0x40 // Drive 1 DMA capable
#define DMA0CAP 0x20 // Drive 0 DMA capable
#define IDEINTS 0x04 // IDE Interrupt Status
#define IDEDMAE 0x02 // IDE DMA error
#define BMIDEA 0x01 // Bus master IDE active
// IDE Command byte fields
#define IDE_SELECT_OFFSET (6)
#define IDE_SELECT_DEV_BIT 0x10
#define IDE_FEATURE_OFFSET IDE_ERROR_OFFSET
#define IDE_COMMAND_OFFSET IDE_STATUS_OFFSET
// PCI device specific register byte offsets
#define PCI_IDE_TIMING 0x40
#define PCI_SLAVE_TIMING 0x44
#define PCI_UDMA33_CTRL 0x48
#define PCI_UDMA33_TIMING 0x4a
#define IDETIM (0)
#define SIDETIM (4)
#define UDMACTL (5)
#define UDMATIM (6)
typedef enum RegType {
COMMAND_BLOCK = 0,
CONTROL_BLOCK,
BMI_BLOCK
} RegType_t;
class IdeDisk;
class IntrControl;
class PciConfigAll;
class Tsunami;
class PhysicalMemory;
class BaseInterface;
class HierParams;
class Bus;
/**
* Device model for an Intel PIIX4 IDE controller
*/
class IdeController : public PciDev
{
private:
/** Primary command block registers */
Addr pri_cmd_addr;
Addr pri_cmd_size;
/** Primary control block registers */
Addr pri_ctrl_addr;
Addr pri_ctrl_size;
/** Secondary command block registers */
Addr sec_cmd_addr;
Addr sec_cmd_size;
/** Secondary control block registers */
Addr sec_ctrl_addr;
Addr sec_ctrl_size;
/** Bus master interface (BMI) registers */
Addr bmi_addr;
Addr bmi_size;
private:
/** Registers used for bus master interface */
uint8_t bmi_regs[16];
/** Shadows of the device select bit */
uint8_t dev[2];
/** Registers used in PCI configuration */
uint8_t pci_regs[8];
// Internal management variables
bool io_enabled;
bool bm_enabled;
bool cmd_in_progress[4];
public:
/** Pointer to the chipset */
Tsunami *tsunami;
private:
/** IDE disks connected to controller */
IdeDisk *disks[4];
private:
/** Parse the access address to pass on to device */
void parseAddr(const Addr &addr, Addr &offset, bool &primary,
RegType_t &type);
/** Select the disk based on the channel and device bit */
int getDisk(bool primary);
/** Select the disk based on a pointer */
int getDisk(IdeDisk *diskPtr);
public:
/** See if a disk is selected based on its pointer */
bool isDiskSelected(IdeDisk *diskPtr);
public:
/**
* Constructs and initializes this controller.
* @param name The name of this controller.
* @param ic The interrupt controller.
* @param mmu The memory controller
* @param cf PCI config space
* @param cd PCI config data
* @param bus_num The PCI bus number
* @param dev_num The PCI device number
* @param func_num The PCI function number
* @param host_bus The host bus to connect to
* @param hier The hierarchy parameters
*/
IdeController(const std::string &name, IntrControl *ic,
const std::vector<IdeDisk *> &new_disks,
MemoryController *mmu, PciConfigAll *cf,
PciConfigData *cd, Tsunami *t,
uint32_t bus_num, uint32_t dev_num, uint32_t func_num,
Bus *host_bus, HierParams *hier);
/**
* Deletes the connected devices.
*/
~IdeController();
virtual void WriteConfig(int offset, int size, uint32_t data);
virtual void ReadConfig(int offset, int size, uint8_t *data);
void intrPost();
void intrClear();
void setDmaComplete(IdeDisk *disk);
/**
* Read a done field for a given target.
* @param req Contains the address of the field to read.
* @param data Return the field read.
* @return The fault condition of the access.
*/
virtual Fault read(MemReqPtr &req, uint8_t *data);
/**
* Write to the mmapped I/O control registers.
* @param req Contains the address to write to.
* @param data The data to write.
* @return The fault condition of the access.
*/
virtual Fault write(MemReqPtr &req, const uint8_t *data);
/**
* Serialize this object to the given output stream.
* @param os The stream to serialize to.
*/
virtual void serialize(std::ostream &os);
/**
* Reconstruct the state of this object from a checkpoint.
* @param cp The checkpoint use.
* @param section The section name of this object
*/
virtual void unserialize(Checkpoint *cp, const std::string &section);
/**
* Return how long this access will take.
* @param req the memory request to calcuate
* @return Tick when the request is done
*/
Tick cacheAccess(MemReqPtr &req);
};
#endif // __IDE_CTRL_HH_