This patch enables a new 'DRAM' mode to the existing traffic
generator, catered to generate specific requests to DRAM based on
required hit length (stride size) and bank utilization. It is an add on
to the Random mode.
The basic idea is to control how many successive packets target the
same page, and how many banks are being used in parallel. This gives a
two-dimensional space that stresses different aspects of the DRAM
timing.
The configuration file needed to use this patch has to be changed as
follow: (reference to Random Mode, LPDDR3 memory type)
'STATE 0 10000000000 RANDOM 50 0 134217728 64 3004 5002 0'
-> 'STATE 0 10000000000 DRAM 50 0 134217728 32 3004 5002 0 96 1024 8 6 1'
The last 4 parameters to be added are:
<stride size (bytes), page size(bytes), number of banks available in DRAM,
number of banks to be utilized, address mapping scheme>
The address mapping information is used to get the stride address
stream of the specified size and to know where to find the bank
bits. The configuration file has a parameter where '0'-> RoCoRaBaCh,
'1'-> RoRaBaCoCh/RoRaBaChCo address-mapping schemes. Note that the
generator currently assumes a single channel and a single rank. This
is to avoid overwhelming the traffic generator with information about
the memory organisation.
This patch addresses an issue with trace playback in the TrafficGen
where the trace was reset but the header was not read from the trace
when a captured trace was played back for a second time. This resulted
in parsing errors as the expected message was not found in the trace
file.
The header check is moved to an init funtion which is called by the
constructor and when the trace is reset. This ensures that the trace
header is read each time when the trace is replayed.
This patch also addresses a small formatting issue in a panic.
This patch adds an optional request elasticity to the traffic
generator, effectievly compensating for it in the case of the linear
and random generators, and adding it in the case of the trace
generator. The accounting is left with the top-level traffic
generator, and the individual generators do the necessary math as part
of determining the next packet tick.
Note that in the linear and random generators we have to compensate
for the blocked time to not be elastic, i.e. without this patch the
aforementioned generators will slow down in the case of back-pressure.
This patch changes the queued port for a conventional master port and
stalls the traffic generator when requests are not immediately
accepted. This is a first step to allowing elasticity in the injection
of requests.
The patch also adds stats for the sent packets and retries, and
slightly changes how the nextPacketTick and getNextPacket
interact. The advancing of the trace is now moved to getNextPacket and
nextPacketTick is only responsible for answering the question when the
next packet should be sent.
This patch moves the responsibility for sending packets out of the
generator states and leaves it with the top-level traffic
generator. The main aim of this patch is to enable a transition to
non-queued ports, i.e. with send/retry flow control, and to do so it
is much more convenient to not wrap the port interactions and instead
leave it all local to the traffic generator.
The generator states now only govern when they are ready to send
something new, and the generation of the packets to send. They thus
have no knowledge of the port that is used.
This patch enables the use of the generator behaviours outside the
TrafficGen module. This is useful e.g. to allow packet replay modes
for other devices in the system without having to replace them with a
TrafficGen in the configuration files.
This change also enables more specific behaviours to be composed as
specific modules, e.g. BaseBandModem can use a number of generators
and have application-specific parameters based around a specific set
of generators.
