minix/drivers/dec21140A
David van Moolenbroek 89332ecdf1 system.conf: subsystem VID/DID matching support
- change "vid/did" to "vid:did", old form still supported for now;
- allow "vid:did/subvid:subdid" specification in system.conf, in
  which case a device will be visible to a driver if the subsystem
  VID/DID also match.

Change-Id: I7aef54da1b0bc81e24b5d98f1a28416f38f8b266
2014-03-01 09:04:57 +01:00
..
dec21140A.c a bit more -Werror compatability 2013-08-20 11:37:40 +02:00
dec21140A.conf system.conf: subsystem VID/DID matching support 2014-03-01 09:04:57 +01:00
dec21140A.h drivers: remove redundant PCI ID tables 2012-03-07 23:58:00 +01:00
Makefile dec21140A: remove ACK option in Makefile 2013-08-06 11:46:22 +02:00
README.txt dec21140A ethernet driver for virtualpc, contributed by nicolas tittley. 2010-01-26 10:20:18 +00:00

README file for the Dec21140A ethernet board driver as emulated by 
Microsoft VirtualPC 2007.

created August 2009, Nicolas Tittley (first.last@gmail)

LIMITATIONS:
------------

This driver supports only the Dec21140A as emulated by VPC2007. It is
untested in any other environment and will probably panic if you use it
outside VPC2007.

The driver supports bridged, nat and local network settings. See the
next section for a remark on seting up a nat environment.

Only one card can be used at a time, do not activate multiple network
cards in VPC2007, the driver will panic.

NOTE FOR USERS CONFIGURING VPC2007 TO USE NAT:

in /usr/etc/rc comment out the following three lines:

trap '' 2
intr -t 20 hostaddr -h
trap 2

VPC2007 does not play well with hostaddr and it will hang the boot process 
until you CTRL-C out of it.