gem5/tests/quick/se/70.tgen/tgen-simple-mem.cfg
Andreas Hansson e76e8e28a3 tests: Add a regression for the stack distance calculator
Re-use the existing traffic generator regression, and enable the stack
distance calculation in the comm monitor, along with the verification
stack.

The traffic generator config is also tuned to not increase the
run-time too much (and actually have some address re-use).
2014-12-23 09:31:18 -05:00

33 lines
1.1 KiB
INI

# This format supports comments using the '#' symbol as the leading
# character of the line
#
# The file format contains [STATE]+ [INIT] [TRANSITION]+ in any order,
# where the states are the nodes in the graph, init describes what
# state to start in, and transition describes the edges of the graph.
#
# STATE <id> <duration (ticks)> <type>
#
# State IDLE idles
#
# States LINEAR and RANDOM have additional <percent reads> <start addr>
# <end addr> <access size (bytes)> <min period (ticks)> <max period (ticks)>
# <data limit (bytes)>
#
# State TRACE plays back a pre-recorded trace once
#
# Addresses are expressed as decimal numbers. The period in the linear
# and random state is from a uniform random distribution over the
# interval. If a specific value is desired, then the min and max can
# be set to the same value.
STATE 0 1000000 TRACE tests/quick/se/70.tgen/tgen-simple-mem.trc 100
STATE 1 100000000 RANDOM 0 0 134217728 64 30000 30000 0
STATE 2 1000000000 IDLE
STATE 3 100000000 LINEAR 0 0 134217728 64 30000 30000 0
STATE 4 1000000 IDLE
INIT 0
TRANSITION 0 1 1
TRANSITION 1 2 1
TRANSITION 2 3 0.5
TRANSITION 2 4 0.5
TRANSITION 3 2 1
TRANSITION 4 4 1